Hand Tool

A Prick Punch is a hand marking tool used to make small, fine indentations on metal surfaces for accurate layout work. It has a sharp pointed tip with a smaller angle (usually around 30°) compared to a center punch, allowing precise marking of layout lines and reference points. This tool is commonly used in fitting and metalworking.

A Divider is a hand marking tool used for measuring distances, transferring measurements, and scribing arcs or circles on a workpiece. It consists of two pointed legs joined at a pivot, allowing adjustment to the required distance. Dividers are widely used in fitting, layout, and workshop marking operations.

A Dot Punch is a hand tool used for marking small indentations on metal surfaces, typically to locate layout points or guide further machining operations. It has a sharper point compared to a center punch, allowing finer and more precise marking. This tool is widely used in fitting and metalworking for layout work.

A Plumber Torch is a hand tool used to produce a controlled flame for heating pipes and fittings during plumbing work. It is commonly used for soldering, brazing, and loosening joints. The torch uses fuel gases such as LPG or propane to generate heat required for joining metal pipes.

A Gas Regulator is a device used in welding to control and maintain a constant pressure of gases such as oxygen or acetylene from the cylinder to the welding equipment. It ensures a safe and steady flow of gas, which is essential for proper flame control during welding operations.

A Cold Chisel is a hand cutting tool used for cutting, shaping, and removing metal without the application of heat. It is commonly used in fitting and fabrication work for cutting rods, rivets, bolts, and metal sheets. The chisel is struck with a hammer to remove material from the workpiece.

A Pipe Bender is a hand tool used to bend pipes and tubes to a desired angle without causing damage or flattening. It is commonly used in plumbing, electrical conduit work, and fabrication. The tool ensures smooth and accurate bends while maintaining the pipe’s shape and strength.

A Round Nose Chisel is a hand cutting tool used for making grooves, oil channels, and semicircular cuts in metal surfaces. It has a curved cutting edge that allows smooth and precise removal of material. It is commonly used in fitting and machining work.

A Sledge Hammer is a heavy-duty striking hand tool used for delivering powerful blows. It has a large, flat metal head and a long handle, allowing the user to generate high force. It is commonly used in construction, demolition, and masonry work for breaking concrete, stones, and driving stakes.

A Rubber Mallet is a striking hand tool with a soft rubber head used for delivering gentle blows without damaging the work surface. It is commonly used in carpentry, woodworking, and assembly work where controlled force is required without leaving marks.